Step One

• Remove slide rail with attached rings (G) and hex head assembly tool (F). Remove rings from slide rail.

Step Two

• Re-install rings to fit between your existing scope mounts. Ring mount that is towards the barrel of the gun should be in the last oval slot.

Step Three

• Remove both bottom halves of rings.

Step Four

• Place rail on top of scope and determine position of rear ring in reference to scope adjustment caps (the slide rail closest to the eye relief on the scope should be 2 inches away from the end of the scope.) Re-install bottom halves onto the scope and semi-tighten the screws.

Step Five

• Remove TrophyShot and battery from case and align battery with the docking station on the front of unit.

Step Six

• Position battery in one hand with unit held in opposite hand; align battery ½ inch over the open edge of docking station; push down and slide battery in place.

Step Seven

• Slide unit onto slide rail from the eye relief side of the scope; snug set screws on the bottom, right side of "Trophy Shot"; pull out camera housing and turn unit on.

Step Eight

• Adjust rail to parallel with scope so you align the crosshairs in the center of the screen.

Step Nine

• Remove unit from top slide rail and tighten ring mounts to secure alignment of TrophyShot. Be sure to tighten all six mounting screws to ensure a stable platform.

Step Ten

• Adjust camera housing to desired depth (close will show a circle picture and further out will show a full screen rectangle picture) and then adjust camera lens to achieve a clear picture.